Slater Designs 5 Piece Action Pad – Kelly's pad of choice (and named after his dog).
More info
Slater Designs 5 Piece Action Pad
Kelly's pad of choice (and named after his dog). The Slater Designs 5 Piece Action Pad is Kelly’s favorite arch, with functional design from Kelly directly. He chopped a ‘ V ‘ into the tail kick to prevent your leash from catching and slit the arch. The arch support is just as wide as on our 3 and 5
Frequently Asked Questions
How do I apply this traction pad?
Clean and dry the board surface thoroughly — the area must be completely free of wax, oils, and moisture. Peel the backing and apply the pad firmly, pressing out any air bubbles from the centre outward. Allow at least 24 hours for the adhesive to cure before surfing.
Will this pad work on any surfboard?
Yes — the pad uses a high-strength marine-grade adhesive that bonds to polyurethane, epoxy, and EPS surfboard surfaces.
How do I remove the pad if I need to?
Carefully lift a corner of the pad and apply gentle heat from a hairdryer to soften the adhesive. Peel slowly at a low angle. Remove any adhesive residue with an adhesive remover before applying a new pad.
Care & Maintenance
Rinse the traction pad with fresh water after each use. Remove sand and debris with a soft-bristle brush. Avoid harsh solvents or abrasive cleaners. Lay flat or hang to dry away from direct sunlight.