Slater Designs 5 Piece Arch Traction Pad – The Slater Designs 5 Piece Arch Traction Pad gives you all the grip you need to feel locked in and push hard and increase speed and drive through every turn.
More info
Slater Designs 5 Piece Arch Traction Pad
The Slater Designs 5 Piece Arch Traction Pad gives you all the grip you need to feel locked in and push hard and increase speed and drive through every turn. The cutouts also create a closer connection to the board, giving you complete control. *** Made with algae. BLOOM is a high-performance flexib
Frequently Asked Questions
How do I apply this traction pad?
Clean and dry the board surface thoroughly — the area must be completely free of wax, oils, and moisture. Peel the backing and apply the pad firmly, pressing out any air bubbles from the centre outward. Allow at least 24 hours for the adhesive to cure before surfing.
Will this pad work on any surfboard?
Yes — the pad uses a high-strength marine-grade adhesive that bonds to polyurethane, epoxy, and EPS surfboard surfaces.
How do I remove the pad if I need to?
Carefully lift a corner of the pad and apply gentle heat from a hairdryer to soften the adhesive. Peel slowly at a low angle. Remove any adhesive residue with an adhesive remover before applying a new pad.
Care & Maintenance
Rinse the traction pad with fresh water after each use. Remove sand and debris with a soft-bristle brush. Avoid harsh solvents or abrasive cleaners. Lay flat or hang to dry away from direct sunlight.