Ocean and Earth Ryan Callinan Pro Series Blue

Ocean and Earth Ryan Callinan Pro Series Blue – Our Ryan Callinan pro series surfboard tail pad is designed by the Mayor of Mereweather himself. A high performance pad, constructed from lightweight, high impact, water resistant EVA. Built for speed and everything you need for taking to the air. Length: 305mm Width: 300mm Pieces: 3 Arch: 7mm Power Kick: 25mm Tread Pattern: Diamond.

What’s in the box:

• 1 x traction tail pad (multi-piece)

• Self-adhesive backing (pre-applied)

FAQ:

Q: How do I install a tail pad?

Thoroughly clean and dry the deck of your board. Peel off the protective backing, position the pad carefully – the kick should align with the tail – and press firmly from the centre outward to remove any air bubbles. Allow at least 24 hours before surfing to ensure a strong bond.

Q: How do I know if this tail pad will fit my board?

Most tail pads fit a wide range of board tails. Check the specifications and compare with your board’s tail width. If in doubt, a slightly smaller pad is easier to trim than one that overhangs.

Care and maintenance:

• Rinse with fresh water after use to remove salt and sand.

• Clean periodically with mild soapy water; avoid petroleum-based solvents.

• Check the adhesive edges regularly and re-glue any lifting sections with contact cement.