Ocean and Earth Fat Boy Black

Ocean and Earth Fat Boy Black – The Fat Boy 3-Piece surfboard tail pad is designed for power surfers with a heavy back foot. The soft base layer acts as a power cushion, allowing you to drive harder and control your board better, while protecting your board from indents. Designed for power surfers who are heavy footed on the tail. Top Layer - Standard weight and hardness Bass Layer - 5mm thickness and softer density EVA. Length: 310mm Width: 300mm Pieces: 3 Arch: 7mm Power Kick: 25mm (Vert) Tread Pattern: Diamond + Thick 5mm base.

What’s in the box:

• 1 x traction tail pad (multi-piece)

• Self-adhesive backing (pre-applied)

FAQ:

Q: How do I install a tail pad?

Thoroughly clean and dry the deck of your board. Peel off the protective backing, position the pad carefully – the kick should align with the tail – and press firmly from the centre outward to remove any air bubbles. Allow at least 24 hours before surfing to ensure a strong bond.

Q: How do I know if this tail pad will fit my board?

Most tail pads fit a wide range of board tails. Check the specifications and compare with your board’s tail width. If in doubt, a slightly smaller pad is easier to trim than one that overhangs.

Care and maintenance:

• Rinse with fresh water after use to remove salt and sand.

• Clean periodically with mild soapy water; avoid petroleum-based solvents.

• Check the adhesive edges regularly and re-glue any lifting sections with contact cement.